Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR GLASS

OUTER REAR VIEW MIRROR GLASS > INSPECTION

for Preparation Click here



1. INSPECT OUTER MIRROR RH
  1. Check the shape of the heater wire.



  1. Check the outer mirror heater operation.


    B360114E02


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Heater Wire Shape A 
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      25°C (77°F)
      7.6 to 11.4 Ω
      Heater Wire Shape B 
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      25°C (77°F)
      9.2 to 13.8 Ω


      Text in Illustration 
      *A
      Heater Wire Shape A
      *B
      Heater Wire Shape B
      *a
      Component without harness connected
      (Outer Mirror RH)
      *b
      Heater Wire
      If the result is not as specified, replace the outer mirror RH.



2. INSPECT OUTER MIRROR LH
  1. Check the shape of the heater wire.



  1. Check the outer mirror heater operation.


    B360115E02


    1. Measure the resistance according the value(s) in the table below.

      Standard Resistance:
      Heater Wire Shape A 
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      25°C (77°F)
      7.6 to 11.4 Ω
      Heater Wire Shape B 
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      25°C (77°F)
      9.2 to 13.8 Ω


      Text in Illustration 
      *A
      Heater Wire Shape A
      *B
      Heater Wire Shape B
      *a
      Component without harness connected
      (Outer Mirror LH)
      *b
      Heater Wire
      If the result is not as specified, replace the outer mirror LH.