Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY

FRONT SEAT SIDE AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT AIRBAG ASSEMBLY

CAUTION:
  1. The nuts must not be reused.
  2. Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.

  1. Install the front seat airbag assembly with 2 new nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Engage the 2 clamps.

  1. Engage the claw and 3 clamps to connect the airbag wire harness.



2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
  1. Temporarily install the separate type front seatback cover with pad.

  1. Engage the 4 claws to install the 2 front seat headrest supports.

  1. Install the 2 brackets with the nut.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    CAUTION:
    1. For vehicles with a front seat airbag assembly, the separate type front seatback cover must be securely installed. Otherwise, the front seat airbag assembly may not deploy properly.
    2. Make sure that the strap is not twisted after installing the nut.
    3. Install the bracket securely.



    B288591
  1. Turn back the separate type front seatback cover.

  1. Using hog ring pliers, install 2 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seatback cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



    B281114
  1. Using hog ring pliers, install 3 new hog rings.

    NOTICE:
    When installing the hog rings, take care to minimize wrinkles as much as possible.



    B281111
  1. Using hog ring pliers, install 5 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seatback cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



3. CONNECT AIRBAG WIRE HARNESS
  1. w/ Seat Heater System:

    1. Engage the clamp.

    2. Connect the connector.

  1. Engage the fastener to install the airbag wire harness.

  1. Connect the rubber band of the separate type front seatback cover with pad.



4. INSTALL FRONT SEAT ASSEMBLY
(Click here)


5. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)