Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY

FRONT SEAT SIDE AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
  1. Be sure to read Precaution thoroughly before servicing (Click here).
  2. Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.
  3. If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage (Click here).

HINT:
Use the same procedure for the LH side and RH side.



1. REMOVE FRONT SEAT ASSEMBLY
(Click here)


2. DISCONNECT AIRBAG WIRE HARNESS


    B281093
  1. Disconnect the rubber band of the separate type front seatback cover with pad.



    B281104
  1. Disengage the fastener to separate the airbag wire harness.



  1. w/ Seat Heater System:



      B281106
    1. Disconnect the connector.

    2. Disengage the clamp.



3. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD


    B281110
  1. Remove the 5 hog rings.



    B281113
  1. Remove the 3 hog rings.



    B280127
  1. Remove the 2 hog rings.

  1. Turn back the separate type front seatback cover.



    B281115
  1. Remove the nut and the 2 brackets.



    B281072
  1. Disengage the 4 claws to remove the 2 front seat headrest supports.

  1. Remove the separate type front seatback cover with pad.



4. REMOVE FRONT SEAT AIRBAG ASSEMBLY


    B281105
  1. Disengage the claw and 3 clamps to disconnect the airbag wire harness.



    B279795
  1. Disengage the 2 clamps.

  1. Remove the 2 nuts and the front seat airbag assembly.

    CAUTION:
    1. The nuts must not be reused.
    2. Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.