COOLER EXPANSION VALVE > REMOVAL |
| 1. RECOVER REFRIGERANT FROM AIR CONDITIONING SYSTEM |
Turn the power switch on (READY).
Turn the A/C switch on.
Operate the air conditioning with a set temperature of 25°C (77°F) and the blower at low for 10 minutes to circulate the refrigerant. This causes most of the compressor oil from the various components of the air conditioning system to collect in the air conditioning compressor.
Turn the power switch off.
Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.
| 2. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY |
| 3. REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD) |
![]() |
Disengage the 2 clamps and separate the wire harness from the front outer cowl top panel subassembly.
![]() |
Remove the 10 bolts and front outer cowl top panel sub-assembly.
| 4. REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD) |
![]() |
Disengage the 2 clamps and separate the wire harness from the front outer cowl top panel sub-assembly.
![]() |
Disengage the 2 clamps and separate the wire harness from the front outer cowl top panel sub-assembly.
![]() |
Remove the 10 bolts and front outer cowl top panel sub-assembly.
| 5. DISCONNECT SUCTION PIPE SUB-ASSEMBLY |
![]() |
Remove the bolt, and slide the hook connector.
Disconnect the suction pipe sub-assembly.
Remove the O-ring from the suction pipe sub-assembly.
| 6. DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY |
Disconnect the air conditioner tube and accessory assembly.
Remove the O-ring from the air conditioner tube and accessory assembly.
| 7. REMOVE COOLER EXPANSION VALVE |
![]() |
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts.
![]() |
Temporarily install the bolt for the suction pipe sub-assembly halfway to the cooler expansion valve.
| *1 | Bolt for Suction Pipe Sub-assembly |
![]() |
Hold the bolt and pull it to remove the cooler expansion valve as shown in the illustration.
![]() |
Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.
| *1 | No. 1 Cooler Evaporator Sub-assembly |