LIGHTING SYSTEM > CUSTOMIZE PARAMETERS |
| 1. CUSTOMIZE LIGHTING SYSTEM (INT) |
Customizing using the intelligent tester
Connect the intelligent tester to the DLC3.
Turn the power switch to on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Utility / Customize / Illuminated Entry.
Select the setting by referring to the table below.
| Tester Display | Default | Content | Setting | Relevant ECU |
| Lighting Time | 15 s | Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off to on (IG) or on (ACC).) | 7.5 s, 15 s or 30 s | Main body ECU (Multiplex network body ECU) |
| I/L when ACC OFF | ON | Lights up the power switch illumination, personal light and rear interior light when the power switch is turned from on (IG) or on (ACC) to off. | ON or OFF | |
| I/L ON W/Door Key Unlock | ON | Lights up the power switch illumination, personal light and rear interior light when doors are unlocked using a mechanical key or door control transmitter. | ON or OFF | |
| Light Control | ON | Dims (ON setting) or turns off (OFF setting) the inside handle illumination lights when all of the following conditions are met:
| ON or OFF | |
| Room Light when Aprchd | ON | Lights up the power switch illumination, personal light and rear interior light when a key enters any actuation area around the doors. | ON or OFF | |
| Inside Foot Light | ON | Lights up the inside handle illumination lights. | ON or OFF | |
| Interior Light Control | ON | Lights up the power switch illumination, personal light, rear interior light and inside handle illumination lights when the illuminated entry function is operating. | ON or OFF |