Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



1. CUSTOMIZE LIGHTING SYSTEM (INT)
  1. Customizing using the intelligent tester

    HINT:
    The following items can be customized.

    NOTICE:
    1. When the customer requests a change in a function, first make sure that the function can be customized.
    2. Be sure to make a note of the current settings before customizing.
    3. When troubleshooting a function, first make sure that the function is set to the default setting.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch to on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Main Body / Utility / Customize / Illuminated Entry.

    5. Select the setting by referring to the table below.

      Illuminated Entry 
      Tester Display
      Default
      Content
      Setting
      Relevant ECU
      Lighting Time
      15 s
      Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off to on (IG) or on (ACC).)
      7.5 s, 15 s or 30 s
      Main body ECU (Multiplex network body ECU)
      I/L when ACC OFF
      ON
      Lights up the power switch illumination, personal light, rear interior light, inside handle illumination lights and footwell lights when the power switch is turned from on (IG) or on (ACC) to off.
      ON or OFF
      I/L ON W/Door Key Unlock
      ON
      Lights up the power switch illumination, personal light and rear interior light when doors are unlocked using a mechanical key or door control transmitter.
      ON or OFF
      Light Control
      ON
      Dims (ON setting) or turns off (OFF setting) the inside handle illumination lights when all of the following conditions are met:
      1. Power switch on (IG)
      2. The shift lever is moved out of P.
      3. All doors are closed.
      ON or OFF
      Room Light when Aprchd
      ON
      Lights up the power switch illumination, personal light and rear interior light when a key enters any actuation area around the doors.
      ON or OFF
      Inside Foot Light
      ON
      Lights up the inside handle illumination lights and footwell lights lights.
      ON or OFF
      Interior Light Control
      ON
      Lights up the power switch illumination, personal light, rear interior light, inside handle illumination lights and footwell lights when the illuminated entry function is operating.
      ON or OFF

  1. Customizing using the multi-display

    1. Turn the power switch to on (IG).

    2. Enter the following menus: Setup / Vehicle / Vehicle customization / Light settings

    3. Select the setting by referring to the table below:

      Display
      Default
      Content
      Setting
      Relevant ECU
      Interior lights off timer
      15 sec.
      Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off to on (IG) or on (ACC).)
      Off, 7.5 sec., 15 sec., or 30 sec.
      Main body ECU (Multiplex network body ECU)