Home › Vehicle Interior › SEAT › REAR SEAT RECLINING CONTROL CABLE

REAR SEAT RECLINING CONTROL CABLE > REMOVAL

for Preparation Click here



1. REMOVE REAR SEAT HEADREST ASSEMBLY


2. REMOVE REAR SEAT CUSHION ASSEMBLY


    B298856E01
  1. Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.
    Standard Measurement 
    a
    100 mm (3.94 in.) or less

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.


    1. Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.

    2. Repeat the step above for the other hook.

  1. Remove the rear seat cushion assembly.

    NOTICE:
    Be careful not to damage the vehicle body.



3. REMOVE REAR SEAT CUSHION LOCK HOOK


    B279203
  1. Disengage the claw and remove the rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure for the LH side and RH side.



4. REMOVE REAR SEATBACK ASSEMBLY RH
  1. Fold down the rear seatback assembly RH.



    B284992E01
  1. Disengage the 3 fasteners as shown in the illustration.
    Text in Illustration 
    *1
    Fastener



    B284994
  1. Remove the 2 bolts and rear seatback assembly RH.

    NOTICE:
    Be careful not to damage the vehicle body.



5. REMOVE NO. 2 ROOM PARTITION COVER


    B284995
  1. Using a moulding remover, disengage the claw and guide, and remove the No. 2 room partition cover.



6. REMOVE REAR SEATBACK ASSEMBLY LH
  1. Disconnect the rear seat outer belt from the rear seat center shoulder belt guide.



    B284997
  1. Pull the cable in the direction shown in the illustration to release the rear seatback lock and then fold the rear seatback assembly LH forward.



    B285007E01
  1. Disengage the fastener as shown in the illustration.
    Text in Illustration 
    *1
    Fastener



    B284998
  1. Remove the 2 bolts and rear seatback assembly LH.

    NOTICE:
    Be careful not to damage the vehicle body.



7. REMOVE REAR SIDE SEATBACK ASSEMBLY LH
  1. Disconnect the rear seat outer belt from the rear seat shoulder belt guide LH.



    B285000
  1. Remove the bolt.

  1. Disengage the hook and remove the rear side seatback assembly LH.

    NOTICE:
    Be careful not to damage the vehicle body.



8. REMOVE REAR SIDE SEATBACK ASSEMBLY RH
  1. Disconnect the rear seat outer belt from the rear seat shoulder belt guide RH.



    B284999
  1. Remove the bolt.

  1. Disengage the hook and remove the rear side seatback assembly RH.

    NOTICE:
    Be careful not to damage the vehicle body.



9. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for LH Side)


    B279440
  1. Remove the bolt and disconnect the floor anchor of the rear seat outer belt assembly.



10. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for RH Side)


    B279442
  1. Remove the bolt and disconnect the floor anchor of the rear seat outer belt assembly.



11. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH


    B298603
  1. Remove the 2 nuts and child restraint seat anchor bracket sub-assembly LH.



12. DISCONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH


    B279454
  1. Remove the bolt and disconnect the floor anchor of the rear seat inner with center belt assembly LH.



13. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
  1. Disconnect the rear door opening trim weatherstrip LH.



14. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
  1. Disconnect the rear door opening trim weatherstrip RH.



15. REMOVE ROOF SIDE INNER GARNISH LH


    B278991
  1. Disengage the 5 clips.

  1. Disengage the guide and remove the roof side inner garnish LH.



16. REMOVE ROOF SIDE INNER GARNISH RH

HINT:
Use the same procedure as for the LH side.



17. REMOVE CENTER STOP LIGHT SET


    E226678E01
  1. Slide the center stop light set in the order and directions shown by the arrows in the illustration while pushing it towards the rear of the vehicle to disengage the 4 claws.



    E231297
  1. Turn the center stop light set 180 degrees as shown by the arrow in the illustration.

    HINT:
    This makes it easier to disconnect the connector.

  1. Disconnect the connector and remove the center stop light set.



18. REMOVE REAR SEAT SHOULDER BELT COVER


    B271099
  1. Using a moulding remover, disengage the 2 claws and 4 guides and remove the rear seat shoulder belt cover.

    HINT:
    Use the same procedure for the other 2 rear seat shoulder belt covers.



19. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY


    B293942E01
  1. Using pliers, disengage the 3 clips from inside the luggage compartment as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the tips of pliers before use.

  1. Disengage the 5 guides.

  1. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.



20. REMOVE ROOM PARTITION BOARD LH


    B285001
  1. Using a clip remover, remove the clip.

  1. Disengage the 5 claws and clip, and remove the room partition board LH.



21. REMOVE ROOM PARTITION BOARD RH


    B285002
  1. Using a clip remover, remove the 4 clips.

  1. Disengage the 4 clips, and remove the room partition board RH.



22. REMOVE REAR SEATBACK LOCK SUB-ASSEMBLY LH


    B285003
  1. Remove the 2 nuts and rear seatback lock sub-assembly LH.



23. REMOVE REAR SEATBACK LOCK SUB-ASSEMBLY RH


    B294600E01
  1. Disengage the hook in the order indicated in the illustration.



    B285006
  1. Remove the 2 nuts and rear seatback lock sub-assembly RH.