CHARGING SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK AUXILIARY BATTERY |
Check that the auxiliary battery cables are connected to the correct terminals.
Check the auxiliary battery for damage and deformation. If severe damage, deformation or leakage is found, replace the auxiliary battery.
| 2. CHECK AUXILIARY BATTERY VOLTAGE |
Turn the power switch off and turn on the high beam headlights for 30 seconds. This will remove the surface charge from the auxiliary battery.
Measure the auxiliary battery voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition | Result |
| Positive (+) terminal - Negative (-) terminal | 20°C (68°F), Power switch off | 12.5 V or higher | Auxiliary battery is OK |
| 11.0 to 12.5 V | Recharge auxiliary battery | ||
| Below 11.0 V | Replace auxiliary battery |
| 3. RECHARGE AUXILIARY BATTERY |
Recharge the auxiliary battery.
| Auxiliary Battery Type | Charging Current |
| S55D23R | 4 to 5 A |
Turn the power switch off and turn on the high beam headlights for 30 seconds. This will remove the surface charge from the auxiliary battery.
Measure the auxiliary battery voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition | Result |
| Positive (+) terminal - Negative (-) terminal | 20°C (68°F), Power switch off | 12.5 V or higher | Auxiliary battery is OK |
| 11.0 to 12.5 V | Recharge auxiliary battery | ||
| Below 11.5 V | Replace auxiliary battery |
| 4. CHECK AUXILIARY BATTERY TERMINAL, FUSIBLE LINK AND FUSE |
Check that the auxiliary battery terminals are not loose or corroded.
Measure the resistance of each fusible link and fuse for the auxiliary battery charging system.
| 5. CHECK AMD TERMINAL |
Check that the service plug grip is not installed.
Check that the AMD terminal is connected securely, and there is no contact problem.
Check that the nuts for the AMD terminal is tightened to the specified torque.
Install the service plug grip.
| 6. CHECK DC/DC CONVERTER FUNCTION |
![]() |
Connect the AC/DC 400 A probe to the positive auxiliary battery cable.
Turn the power switch on (READY) and leave the vehicle as it is until the electric current flowing into the auxiliary battery becomes 10 A or less.
Turn the power switch on (READY) and the headlight position switch and blower motor switch in the HI position, and the rear window defogger turned on.
![]() |
Measure the current and voltage according to the value(s) in the table below.
| Item | Tester Connection | Condition | Specified Condition |
| Current flowing from auxiliary battery | Auxiliary battery positive cable | Power switch on (READY) (The headlight position switch and blower motor switch are in the HI position, and the rear window defogger is turned on.) | 0 A or less (no current from auxiliary battery) |
| Auxiliary battery voltage | Positive (+) terminal - Negative (-) terminal | 13 to 15 V |