Home › Vehicle Interior › HEATING / AIR CONDITIONING › REFRIGERANT LINE

REFRIGERANT LINE > REMOVAL

for Preparation Click here



1. REMOVE PIPING CLAMP


    E232146E01
  1. While pressing the end of the suction hose sub-assembly to the end of the suction pipe sub-assembly, use pliers to squeeze together both sides of the piping clamp until it breaks apart.
    Text in Illustration 
    *1
    Piping Clamp

    NOTICE:
    Make sure that fragments of the piping clamp do not enter the piping.

  1. Separate the suction hose sub-assembly.

    NOTICE:
    Clean off any dirt or water near the ends of the suction hose sub-assembly and suction tube sub-assembly.

  1. Remove the 2 O-rings from the suction hose sub-assembly.

    NOTICE:
    Wrap the open ends of the separated suction pipe sub-assembly and suction hose sub-assembly with vinyl tape to prevent dirt or water from entering.