MOTOR WATER JACKET COVER ASSEMBLY > REMOVAL |
| 1. DRAIN COOLANT (for Inverter) |
Remove the reserve tank cap.
![]() |
Using a hexagon wrench (10 mm), remove the drain plug indicated in the illustration and drain the coolant.
Install the plug with a new gasket.
| 2. REMOVE NO. 2 MOTOR WATER JACKET COVER ASSEMBLY |
![]() |
Remove the 5 bolts.
Insert the blade of an oil pan seal cutter between the transaxle housing. Cut through the applied sealer and remove the No. 2 motor water jacket cover assembly.
| 3. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY |
| 4. REMOVE FRONT ENGINE MOUNTING BRACKET |
![]() |
Remove the 3 bolts and front engine mounting bracket from the hybrid vehicle transaxle assembly.
| 5. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET |
![]() |
Remove the 2 bolts and No. 1 transmission control cable bracket from the hybrid vehicle transaxle assembly.
| 6. REMOVE AUTOMATIC TRANSMISSION CASE COVER |
![]() |
Remove the 2 bolts, clip and automatic transmission case cover from the hybrid vehicle transaxle assembly.
| 7. REMOVE NO. 1 MOTOR WATER JACKET COVER ASSEMBLY |
![]() |
Remove the 8 bolts.
Insert the blade of an oil pan seal cutter between the transaxle housing. Cut through the applied sealer and remove the No. 1 motor water jacket cover assembly.