SHIFT LEVER > INSPECTION |
| 1. INSPECT LOWER SHIFT LEVER ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 5 (IG) - Body ground | Power switch on (IG) | 11 to 14 V |
| Power switch off | Below 1 V | |
| 4 (STP) - Body ground | Brake pedal depressed | 11 to 14 V |
| Brake pedal released | Below 1 V |
| *a | Component with harness connected: (Shift Lock Control ECU) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (E) - Body ground | Always | Below 1 Ω |
| *a | Component with harness connected: (Shift Lock Control ECU) |
Inspect shift lock solenoid
![]() |
Disconnect the shift lock solenoid connector.
![]() |
Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.
| Tester Connection | Shift Lever Position | Specified Condition |
| 4 (P) - 3 (E2) | P | 10 kΩ or higher |
| 4 (P) - 3 (E2) | Other than P | Below 1 Ω |
| *a | Front view of wire harness connector: (to Shift Lock Solenoid) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (SLS+) - 2 (SLS-) | Always | 112 Ω |