Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT CIRCUIT OPENING RELAY ASSEMBLY


    A188757E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Auxiliary battery voltage not applied between terminals 1 and 2
    10 kΩ or higher
    Auxiliary battery voltage applied between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the circuit opening relay assembly (C/OPN).