WORK NOTICES AND PRECAUTIONS > PRECAUTIONS FOR SRS AIRBAG SYSTEM



HANDLING OF A VEHICLE THAT HAS BEEN DAMAGED IN A COLLISION (for TMMK Made)
  1. Refer to the TOYOTA Repair Manual for the SRS airbag system inspection procedures.

  2. If impacts are likely to occur to the front airbag sensors, side airbag sensors, rear airbag sensors or center airbag sensor remove each sensor as necessary beforehand.

  3. Do not allow the front airbag sensors, side airbag sensors, rear airbag sensors or center airbag sensor to become heated to high temperatures.

  4. Check the wire harnesses and connectors for damage and/or melting, as some areas of the airbags and seat belt pretensioners may heat up to several hundred degrees when they operate.


PRECAUTIONS FOR USING ELECTRIC WELDER
  1. Check the Diagnostic Trouble Codes (DTCs).

    1. If one or more DTCs are displayed:

      1. Disconnect the negative (-) terminal cable from the battery.
      2. Disconnect all the malfunctioning circuit connectors.
      3. Disconnect the center airbag sensor assembly connector.

    2. If DTCs are NOT displayed:

      1. Inspect for damage to the electric wiring harnesses and connectors.
      2. Disconnect the negative (-) terminal cable from the battery.
      3. Disconnect the center airbag sensor assembly connector.


PARTS LOCATION

C308896E01


C308872E01


C308873E01


HANDLING OF A VEHICLE THAT HAS BEEN DAMAGED IN A COLLISION (for TMC, TMMR Made)
  1. Refer to the TOYOTA Repair Manual for the SRS airbag system inspection procedures.

  2. If impacts are likely to occur to the front airbag sensors, side airbag sensors, rear airbag sensors or center airbag sensor remove each sensor as necessary beforehand.

  3. Do not allow the front airbag sensors, side airbag sensors, rear airbag sensors or center airbag sensor to become heated to high temperatures.

  4. Check the wire harnesses and connectors for damage and/or melting, as some areas of the airbags and seat belt pretensioners may heat up to several hundred degrees when they operate.


PRECAUTIONS FOR USING ELECTRIC WELDER
  1. Check the Diagnostic Trouble Codes (DTCs).

    1. If one or more DTCs are displayed:

      1. Disconnect the negative (-) terminal cable from the battery.
      2. Disconnect all the malfunctioning circuit connectors.
      3. Disconnect the center airbag sensor assembly connector.

    2. If DTCs are NOT displayed:

      1. Inspect for damage to the electric wiring harnesses and connectors.
      2. Disconnect the negative (-) terminal cable from the battery.
      3. Disconnect the center airbag sensor assembly connector.


PARTS LOCATION

C310717E01


C308876E01


C308877E01