QUARTER WHEEL HOUSING OUTER PANEL > ASSEMBLY REPLACEMENT



  1. K101319
    With the quarter panel removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100015
Remove Weld Points
K100016
Remove Weld Points
K100022
Cut with Disc Sander etc.
K100023
Cut and Join Location
REMOVAL POINT (for TMC, TMMR Made)
  1. rocker extension outer is reused.
  2. After removing the rocker extension outer and roof side panel outer remove the quarter wheel house panel outer.
  3. Carefully cut the rocker reinforce outer so not to damage *1.
REMOVAL POINT (for TMMK Made)
  1. rocker reinforce outer is reused.
  2. After removing the rocker reinforce outer and roof side panel outer remove the quarter wheel house panel outer.
  3. Carefully cut the rocker reinforce outer so not to damage *1.

K101320E04


K101321E02


K101322E04


K101323E02


K102149E04


K102150E02


K102151E02


K102152E02


INSTALLATION

Symbol meaning
K100017
Spot Weld
K100019
Plug Weld
K100020
Plug Weld
K100021
Plug Weld
K100026
Fillet Weld
K100027
Butt Weld
K100030
Body Sealer
K100031
Assembly Mark
INSTALLATION POINT (for TMC, TMMR Made)
  1. For positioning of the new parts, align the installation standard holes of the outer panel and the inner panel.
  2. When welding *1, make a hole on a new part for plug welding and weld the panel with the panel behind completely.
  3. Before installing a new part, apply body sealer.

    HINT:
    Apply body sealer in an even, continuous bead.

  4. After welding the quarter wheel house panel outer to the vehicle side, install the roof side panel outer and rocker extension outer.
  5. After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
  6. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
INSTALLATION POINT (for TMMK Made)
  1. For positioning of the new parts, align the installation standard holes of the outer panel and the inner panel.
  2. When welding *1, make a hole on a new part for plug welding and weld the panel with the panel behind completely.
  3. Before installing a new part, apply body sealer.

    HINT:
    Apply body sealer in an even, continuous bead.

  4. After welding the quarter wheel house panel outer to the vehicle side, install the roof side panel outer and rocker reinforce outer.
  5. After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
  6. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K101324E02


K101325E03


K101326E02


K101327E03


K102154E03


K102153E02


K102156E02


K102155E02