With the rear floor rear inner crossmember removed.
REMOVAL
Symbol meaning
Remove Weld Points
Remove Weld Points
INSTALLATION
Symbol meaning
Plug Weld
Plug Weld
Assembly Mark
INSTALLATION POINT
For positioning of the new parts, align the installation standard holes of the rear floor side rear member and the member.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram)
After welding, apply undercoating to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.