FRONT SIDE MEMBER > ASSEMBLY REPLACEMENT (PATTERN 2) | |
- With the radiator support and front fender apron removed.
Symbol meaning
|

| Remove Weld Points
|
Symbol meaning
|

| Plug Weld
|
INSTALLATION POINT (for TMC, TMMR Made)
- Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
- Make sure to attach correctly in accordance with the body dimension diagram as this part affects the front wheel alignment.
- After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
- After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
INSTALLATION POINT (for TMMK Made)
- Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
- If the entire supply part is not needed, remove the part of the supply part that is needed.
- Make sure to attach correctly in accordance with the body dimension diagram as this part affects the front wheel alignment.
- After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
- After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.