ROCKER REAR PANEL > CUT AND JOIN REPLACEMENT SECTIONS | |
- With the Quarter Panel removed.
Symbol meaning
|

| Remove Weld Points
|

| Cut with Disc Sander etc.
|

| Cut Location for Supply Parts
|
REMOVAL POINT
- *1 is reused.
Symbol meaning
|

| Plug Weld
|

| Plug Weld
|

| Butt Weld
|

| Body Sealer
|
INSTALLATION POINT (for TMC, TMMR Made)
- If the entire supply part is not needed, remove the part of the supply part that is needed.
- Before temporarily installing the new parts, weld the center body pillar reinforce lower, rocker extension outer and rocker panel reinforcement with the standard number of welding points.
- After welding the center body pillar reinforce lower, rocker extension outer and rocker panel reinforcement to the vehicle side, install the *1.
- After welding, apply body sealer to the corresponding parts. (See the painting / coating)
- After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
INSTALLATION POINT ( for TMMK Made)
- If the entire supply part is not needed, remove the part of the supply part that is needed.
- Before temporarily installing the new parts, weld the center body pillar reinforce lower and rocker reinforce outer with the standard number of welding points.
- After welding the center body pillar reinforce lower and rocker reinforce outer to the vehicle side, install the *1.
- After welding, apply body sealer to the corresponding parts. (See the painting / coating)
- After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.