ENGINE COMPARTMENT REFERENCE VALUES > THREE-DIMENSIONAL DISTANCE



for TMC, TMMR Made

HINT:
  1. Measure points with the cool air intake duct seal removed.
  2. In cases in which only one dimension is given, left and right are symmetrical.
  3. For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).


Measuring Point Name 
Symbol
Name
Hole Diameter
mm (in.)
A, a
Radiator Upper Support Standard Hole
φ10 (0.39)
B, b
Headlight Installation Screw
-
C, c
Front Fender Installation Bolt
M6 (0.24)
D, d
Front Fender Installation Bolt
M6 (0.24)
E, e
Front Fender Installation Bolt
M6 (0.24)

K122839E01


for TMMK Made

HINT:
  1. Measure points with the cool air intake duct seal removed.
  2. In cases in which only one dimension is given, left and right are symmetrical.
  3. For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).


Measuring Point Name 
Symbol
Name
Hole Diameter
mm (in.)
A, a
Radiator Upper Support Standard Hole
φ10 (0.39)
B, b
Headlight Installation Screw
-
C, c
Front Fender Installation Bolt
M6 (0.24)
D, d
Front Fender Installation Bolt
M6 (0.24)
E, e
Front Fender Installation Bolt
M6 (0.24)

K122840E01