ENGINE UNIT > GENERAL



OUTLINE


  1. The 2AR-FE engine is an in-line 4-cylinder, 2.5 liter, 16 valve DOHC engine. This engine uses the Dual Variable Valve Timing-intelligent (VVT-i) system, Direct Ignition System (DIS), Acoustic Control Induction System (ACIS) and Electronic Throttle Control System-intelligent (ETCS-i). These control functions achieve improved engine performance, fuel economy, and clean emissions.


    W104652


MAJOR DIFFERENCE
  1. The new models have been modified from the previous models as shown below:

    1. TMMK made models have been added.


SPECIFICATION

Engine Type
2AR-FE
No. of Cyls. & Arrangement
4-cylinder, In-line
Valve Mechanism
16-valve DOHC, Chain Drive
(With Dual VVT-i)
Combustion Chamber
Pentroof Type
Flow of Intake and Exhaust Gasses
Cross-flow
Fuel System
SFI
Ignition System
DIS
Displacement
cm3 (cu. in.)
2494 (152.2)
Bore X Stroke
mm (in.)
90.0 X 98.0 (3.54 X 3.86)
Compression Ratio
10.4 : 1
Max. Output (EEC)
kW@rpm
133@6000
Max. Torque (EEC)
N*m@rpm
231@4100
Oil Capacity
Dry
liters (US qts, Imp. qts)
5.3 (5.6, 4.7)
With Oil Filter
liters (US qts, Imp. qts)
4.4 (4.6, 3.9)
Without Oil Filter
liters (US qts, Imp. qts)
4.0 (4.2, 3.5)
Oil Grade
API grade SL "Energy-Conserving", SM "Energy-Conserving" or ILSAC multigrade engine oil
Engine Coolant
Type
TOYOTA Genuine Super Long Life
Coolant or the following*1
Capacity
liters (US qts, Imp. qts)
7.3 (7.7, 6.4)*2
7.0 (7.4, 6.2)*3
6.9 (7.3, 6.0)*4
Spark Plug
Type
DENSO Made
SK16HR11 (Iridium)
Plug Gap
mm (in.)
1.0 to 1.1 (0.0394 to 0.0433)
Firing Order
1 - 3 - 4 - 2
Fuel Octane Number
91 or higher
Emission Regulation
EURO III*2
EURO IV*5
EURO V*6
Engine Service Mass*7 (Reference)
kg (lb)
122 (269)
  1. *1: Similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology (Coolant with long-life hybrid organic acid technology consists of a combination of low phosphates and organic acids).
  2. *2: TMMK made models
  3. *3: Except models for Russia
  4. *4: Models for Russia
  5. *5: Except destination packages for Hong Kong and Argentina
  6. *6: Destination packages for Hong Kong and Argentina
  7. *7: The figure shown is the weight of the part without coolant and oil.

W104505E01


MAIN FEATURES
  1. The 2AR-FE engine has achieved the following through the use of the items listed in the table below.

    1. High performance and reliability

    2. Low noise and vibration

    3. Lightweight and compact design

    4. Good serviceability

    5. Clean emissions and improved fuel economy

      Item
      (1)
      (2)
      (3)
      (4)
      (5)
      Engine Proper
      A cylinder head cover sub-assembly made of magnesium alloy is used.
      -
      -
      ○
      -
      -
      A taper squish shape is used for combustion chambers.
      ○
      -
      -
      -
      ○
      Spiny-type liners are used in the cylinder bores.
      ○
      -
      ○
      -
      ○
      A water jacket spacer is used.
      ○
      -
      -
      -
      ○
      The piston skirt is coated with resin.
      ○
      ○
      -
      -
      ○
      Low tension piston rings are used.
      ○
      -
      -
      -
      ○
      A resin gear balance shaft is used.
      -
      ○
      ○
      -
      -
      Valve Mechanism
      The Dual Variable Valve Timing-intelligent (VVT-i) system is used.
      ○
      -
      -
      -
      ○
      A chain sub-assembly and No. 1 chain tensioner assembly are used.
      -
      ○
      -
      ○
      -
      Valve lash adjuster assemblies are used.
      ○
      ○
      -
      ○
      -
      No. 1 valve rocker arm sub-assemblies are used.
      ○
      -
      -
      -
      ○
      Lubrication System
      An oil filter with a replaceable element is used.
      -
      -
      -
      ○
      -
      Cooling System
      TOYOTA Genuine Super Long Life Coolant (SLLC) is used.
      -
      -
      -
      ○
      -
      Intake and Exhaust System
      An intake manifold made of plastic is used.
      -
      -
      ○
      -
      -
      A linkless type throttle body with motor assembly is used.
      -
      -
      ○
      ○
      -
      A stainless steel exhaust manifold sub-assembly is used.
      -
      -
      ○
      -
      ○
      An ultra thin-wall, high-cell density ceramic type Three-Way Catalytic converter (TWC) is used.
      -
      -
      -
      -
      ○
      Fuel System
      A fuel returnless system is used.
      -
      -
      ○
      ○
      ○
      Quick connectors are used to connect the fuel hose with the fuel pipe.
      -
      -
      -
      ○
      -
      Compact 12-hole type fuel injector assemblies are used.
      ○
      -
      -
      -
      ○
      Ignition System
      The Direct Ignition System (DIS) is used.
      ○
      -
      -
      ○
      ○
      Long-reach type iridium-tipped spark plugs are used.
      ○
      -
      -
      ○
      ○
      Charging System
      A segment conductor type generator assembly is used.
      ○
      -
      ○
      -
      -
      A generator clutch pulley with a one-way clutch is used.
      ○
      -
      -
      -
      ○
      Starting System
      A planetary reduction-segment conductor motor type starter assembly is used.
      -
      -
      ○
      -
      -
      Serpentine Belt Drive System
      A serpentine belt drive system is used.
      -
      -
      ○
      ○
      -
      Engine Control System
      Magnetic Resistance Element (MRE) type camshaft position sensors are used.
      ○
      -
      -
      -
      ○
      The Electronic Throttle Control System-intelligent (ETCS-i) is used.
      ○
      -
      -
      -
      ○
      An Acoustic Control Induction System (ACIS) is used.
      ○
      -
      -
      -
      -
      The cranking hold function* is used.
      ○
      -
      -
      -
      -
      An evaporative emission control system is used.
      -
      -
      -
      -
      ○
      *: Models with smart entry and start system
      ○: Applicable
      -: Not applicable