ENGINE UNIT > GENERAL



OUTLINE
  1. The 6AR-FSE engine is an in-line 4-cylinder, 2.0 liter, 16 valve DOHC engine.

  2. This engine uses a high-expansion ratio Atkinson cycle, Direct injection 4-stroke gasoline engine Superior version (D-4S) system, Variable Valve Timing-intelligent Wide (VVT-iW) system, Variable Valve Timing-intelligent (VVT-i) system, Direct Ignition System (DIS), Electronic Throttle Control System-intelligent (ETCS-i) and Exhaust Gas Recirculation (EGR) system employing a highly efficient EGR cooler. Thus, improved engine performance, quietness, fuel economy, and cleaner emissions have been achieved.


SPECIFICATION

Engine Type
6AR-FSE
No. of Cyls. & Arrangement
4-cylinder, In-line
Valve Mechanism
16-valve DOHC, Chain Drive
(With VVT-iW and VVT-i)
Combustion Chamber
Pentroof Type
Flow of Intake and Exhaust Gasses
Cross-flow
Fuel System
Sequential Multiport Fuel Injection (SFI) D-4S
Ignition System
Direct Ignition System (DIS)
Displacement
cm3 (cu. in.)
1998 (121.9)
Bore X Stroke
mm (in.)
86.0 X 86.0 (3.39 X 3.39)
Compression Ratio
12.7 : 1
Max. Output (EEC)
kW@rpm
110@6500
Max. Torque (EEC)
N*m@rpm
199@4600
Oil Capacity
Dry
liters (US qts, Imp. qts)
5.3 (5.6, 4.7)
With Oil Filter
liters (US qts, Imp. qts)
4.4 (4.6, 3.9)
Without Oil Filter
liters (US qts, Imp. qts)
4.0 (4.2, 3.5)
Oil Grade
API grade SL "Energy-Conserving", SM "Energy- Conserving", SN "Resource-Conserving" or ILSAC multigrade engine oil
Engine Coolant
Type
TOYOTA Genuine Super Long Life Coolant or the following*1
Capacity
liters (US qts, Imp. qts)
7.3 (7.7, 6.4)
Spark Plug
Type
DENSO Made
FK16HBR-J8
Plug Gap
mm (in.)
0.7 to 0.8 (0.0276 to 0.0315)
Firing Order
1 - 3 - 4 - 2
Research Octane Number
91 or higher
Emission Regulation
EURO V
Engine Service Mass*2 (Reference)
kg (lb)
135 (298)
  1. *1: Similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology (coolant with long-life hybrid organic acid technology consists of a combination of low phosphates and organic acids).
  2. *2: The figure shown is the weight of the part without coolant and oil.

W126943E01


MAIN FEATURES
  1. The 6AR-FSE engine has achieved the following through the use of the items listed in the table below.

    1. High performance and reliability

    2. Low noise and vibration

    3. Lightweight and compact design

    4. Good serviceability

    5. Clean emissions and improved fuel economy

      Item
      (1)
      (2)
      (3)
      (4)
      (5)
      Engine Proper
      The high-expansion ratio Atkinson cycle is adopted.
      ○
      -
      -
      -
      ○
      A cylinder head cover sub-assembly made of aluminum alloy is used.
      -
      -
      ○
      -
      -
      A taper squish shape is used for combustion chambers.
      ○
      -
      -
      -
      ○
      Spiny-type liners are used in the cylinder bores.
      ○
      -
      -
      -
      -
      A cylinder block water jacket spacer is used.
      ○
      -
      -
      -
      ○
      The piston skirt is coated with resin.
      ○
      ○
      -
      -
      ○
      Low-tension piston rings are used.
      ○
      -
      -
      -
      ○
      An offset crankshaft is used.
      ○
      ○
      -
      -
      ○
      A resin gear engine balancer assembly is used.
      -
      ○
      ○
      -
      -
      Valve Mechanism
      The Variable Valve Timing-intelligent Wide (VVT-iW) system is used.
      ○
      -
      -
      -
      ○
      The Variable Valve Timing-intelligent (VVT-i) system is used.
      ○
      -
      -
      -
      ○
      A chain sub-assembly and No. 1 chain tensioner assembly are used.
      -
      ○
      -
      ○
      -
      Valve lash adjuster assemblies are used.
      ○
      ○
      -
      ○
      -
      No. 1 valve rocker arm sub-assemblies are used.
      ○
      -
      -
      -
      ○
      Lubrication System
      An oil filter with a replaceable element is used.
      -
      -
      -
      ○
      -
      An engine oil level sensor is used.
      -
      -
      -
      -
      ○
      Cooling System
      TOYOTA Genuine Super Long Life Coolant (SLLC) is used.
      -
      -
      -
      ○
      -
      Intake and Exhaust System
      An intake manifold made of plastic is used.
      -
      ○
      ○
      -
      -
      A linkless type throttle body with motor assembly is used.
      -
      -
      ○
      ○
      -
      A stainless steel exhaust manifold sub-assembly is used.
      -
      -
      ○
      -
      -
      Emission Control System
      A step motor type Exhaust Gas Recirculation (EGR) valve is used.
      ○
      -
      -
      -
      ○
      A water-cooled type Exhaust Gas Recirculation (EGR) cooler is used.
      ○
      -
      -
      -
      ○
      An ultra thin-wall, high-cell density ceramic type Three-Way Catalytic converter (TWC) is used.
      -
      -
      -
      -
      ○
      Fuel System
      A Direct injection 4-stroke gasoline engine Superior version (D-4S) system is used.
      ○
      -
      -
      -
      ○
      A fuel returnless system is used.
      -
      -
      ○
      ○
      ○
      Quick connectors are used to connect the fuel hose with the fuel pipe.
      -
      -
      -
      ○
      -
      Compact 12-hole type fuel injector assemblies are used.
      ○
      -
      -
      -
      ○
      Single slit nozzle type high pressure fuel injector assemblies are used.
      ○
      ○
      -
      -
      ○
      Ignition System
      The Direct Ignition System (DIS) is used.
      ○
      -
      -
      ○
      ○
      Long-reach type iridium-tipped spark plugs are used.
      ○
      -
      -
      ○
      ○
      Engine Control System
      Magnetic Resistance Element (MRE) type camshaft position sensors and crankshaft position sensor are used.
      ○
      -
      -
      -
      ○
      The Electronic Throttle Control System-intelligent (ETCS-i) is used.
      ○
      -
      -
      -
      ○
      The cranking hold function is used.
      ○
      -
      -
      -
      -
      An evaporative emission control system is used.
      -
      -
      -
      -
      ○
      ○: Applicable
      -: Not applicable