Function
| Outline
|
Constant Speed Control
| The ECM compares the actual vehicle speed and the set speed and if the vehicle speed is lower than the set speed, it uses the throttle control motor to increase the throttle valve opening angle.
|
Set Control
| - When this system fulfils the following conditions, and the cruise control switch is moved to the -SET side and released, the ECM stores the vehicle speed and maintains the vehicle constantly at that speed.
- The cruise control system has been turned on using the ON-OFF button on the cruise control switch.
- The vehicle is being driven at a speed of approximately 40 km/h (25 mph) or more.
|
Low Speed Limit Control
| The low speed limit is the lowest speed that cruise control can be set at and it is designed to be approximately 40 km/h (25 mph). The cruise control system cannot be set below that speed. If the vehicle speed drops below that speed while the cruise control system is set and working to maintain vehicle speed, speed control by the cruise control system will be canceled automatically. However, the set speed is kept in memory.
|
COAST Switch Control
| - When the cruise control switch is held to the -SET side, the vehicle speed and the set vehicle speed change as follows:
- The vehicle will decelerate.
- The set vehicle speed will change to the speed at which the vehicle is being driven when the COAST switch (-SET side operation) is released.
|
Tap Down Control
| - When the cruise control switch is moved momentarily (approximately 0.6 seconds or less) to the -SET side, the vehicle speed and the set vehicle speed change as follows:
- The vehicle will decelerate in increments of approximately 1 km/h (0.6 mph) each time the switch is moved.
- However, if the difference between the actual vehicle speed and the set vehicle speed is greater than 5 km/h (3 mph), the set vehicle speed will change to the speed at which the vehicle is being driven when the switch is pushed.
|
ACC Switch Control
| - When the cruise control switch is held to the +RES side, the vehicle speed and the set vehicle speed change as follows:
- The vehicle will accelerate.
- The set vehicle speed will change to the speed at which the vehicle is being driven when the switch is released.
|
Tap Up Control
| - When the cruise control switch is moved momentarily (approximately 0.6 seconds or less) to the +RES side, the vehicle speed and the set vehicle speed change as follows:
- The vehicle will accelerate in increments of approximately 1 km/h (0.6 mph) each time the switch is moved.
- However, if the difference between the actual vehicle speed and the set vehicle speed is greater than 5 km/h (3 mph), the set vehicle speed will not change.
|
RES Switch Control
| If the vehicle speed is above the low speed limit, the cruise control resumes operation (when the cruise control switch is subsequently pushed to the +RES side) to reach the vehicle speed that was set at the time the driver canceled cruise control.
|
Manual Cancel Control
| - If any of the following signals are sent to the ECM, speed control by the cruise control system is canceled accordingly.
- Shift lever is moved from D or S to any other position.
- When 1st, 2nd or 3rd range is selected in S mode.
- When 1st, 2nd or 3rd range is selected using a shift paddle switch while shift lever is in D or S.*
- Stop light switch assembly on signal (The brake pedal is depressed.)
- CANCEL switch on signal (The cruise control switch is moved to the CANCEL side.)
- Cruise control switch (ON-OFF button) off signal.
|
Automatic Cancel Control
| - If any of the following conditions occur while the cruise control system is controlling vehicle speed, the speed that is set in memory is cleared and speed control by the cruise control system is canceled.
- Stop light switch assembly open or short circuit
- Vehicle speed signals are abnormal.
Furthermore, the cruise control indicator will turn off and a message indicating a malfunction will be displayed on the multi-information display until the cruise control system is turned off using the cruise control switch, and speed control by the cruise control system is disabled until the cruise control system is turned on again using the ON-OFF button.
|
- If the following condition occurs while the cruise control system is controlling vehicle speed, the speed that is set in memory is cleared and speed control by the cruise control system is canceled.
- ETCS-i malfunction
Furthermore, speed control by the cruise control system is disabled until the cruise control system is turned on again using the ON-OFF button.
|
- If any of the following conditions occur while the cruise control system is controlling vehicle speed, the speed that is set in memory is cleared and speed control by the cruise control system is canceled.
- Stop light switch assembly input signal is abnormal
- Cancel circuit malfunction
Furthermore, the cruise control indicator will turn off and a message indicating a malfunction will be displayed on the multi-information display until the cruise control system is turned off using the cruise control switch, and speed control by the cruise control system is disabled until the ignition switch is turned off.
|
- If the following condition occurs while the cruise control system is controlling vehicle speed, the speed that is set in memory is cleared and speed control by the cruise control system is canceled.
- Vehicle speed decreases by 16 km/h (10 mph) or more below the speed at which the cruise control is set.
|
- If the following condition occurs while the cruise control system is controlling vehicle speed, speed control by the cruise control system is canceled.
- Vehicle speed decreases below the low speed limit (approximately 40 km/h [25 mph]).
|
Shift-down Control
| When the vehicle is traveling uphill using cruise control, automatic transmission control may cause the transmission to shift down. During shift-down control, when the end of uphill travel is determined based on the throttle valve angle, the transmission will shift up after a certain period of time. When the transmission shifts down during ACC switch control or RES switch control, the transmission will shift up after ACC switch control or RES switch control ends.
|
Other Cancelation Conditions
| - TRC operates for a certain period of time during cruise control driving.
- VSC operation.
- VSC OFF (TRC OFF) switch on signal.
|