PARKING ASSIST MONITOR SYSTEM > DETAILS



FUNCTION OF MAIN COMPONENTS

Component
Function
Rear Television Camera Assembly
  1. Captures images of the area behind the vehicle.
  2. The parking assist guide lines that are calculated based on signals from the steering sensor are superimposed on the captured image. Then, the image is sent to the radio and display receiver assembly as video signals.
  3. When the luggage compartment door is open, superimposing of parking assist guide lines is canceled and only the captured image is sent as video signals.
Radio and Display Receiver Assembly
Displays images of the area behind the vehicle sent from the rear television camera assembly using the multi-display.
Park/Neutral Position Switch Assembly
Sends an R shift position signal to the ECM.
ECM
Sends an R shift position signal to the rear television camera assembly.
Steering Sensor
Detects the angle of the steering wheel and sends the resulting signals to the rear television camera assembly.
Brake Actuator Assembly
- Skid Control ECU
Sends the wheel speed signal to the rear television camera assembly.
Luggage Compartment Door Lock Assembly
- Luggage Compartment Door Courtesy Switch
Sends the luggage compartment door courtesy switch signal to the main body ECU (multiplex network body ECU).
Main Body ECU (Multiplex Network Body ECU)
Sends the luggage compartment door courtesy switch signal to the rear television camera assembly.
Clearance Warning ECU Assembly
Sends a clearance sonar information signal to the rear television camera assembly.
Power Steering ECU Assembly
Sends a steering type information signal to the rear television camera assembly.
Network Gateway ECU
Relays and transmits data between CAN buses.

OPERATING CONDITION
  1. The parking assist monitor system operates when both of the following conditions are met:

    1. Ignition switch ON.
    2. Shift lever in R.


FUNCTION


  1. Area Displayed on Screen

    1. Objects on the right of the vehicle appear on the right side of the display panel, and objects on the left of the vehicle appear on the left side of the display panel.



    2. The television camera uses a wide-angle lens. The perceived distance from images that appear on the screen differs from the actual distance.


      Y170688

      NOTICE:
      The area displayed on the screen may vary according to vehicle status or road conditions. The area covered by the rear television camera assembly is limited. The rear television camera assembly does not show objects close to either corner of the bumper or show the area under the bumper.

  2. Warning Message

    1. A warning message appears at the bottom of the screen under the following condition. The warning message appears in the same language that has been selected by the language selector of the multi-display.

      Message Appearing at Bottom of Screen 
      Warning Message
      Condition
      Check surroundings for safety.
      This message always appears during system operation.

  3. Calibration Following Parts Replacement

    1. The items listed below must always be adjusted whenever one of the following conditions occurs. For details, refer to the Repair Manual.

      Adjustment Items
      Condition
      Neutral steering point in memory
      Estimated course lines are not displayed.
      Steering angle setting
      1. After spiral cable sub-assembly is removed and installed or after connector is disconnected and reconnected, system initializing is displayed.
      2. After steering sensor is removed and installed or after connector is disconnected and reconnected, system initializing is displayed.
      3. Steering sensor replacement.
      Camera optical axis adjustment
      1. Vehicle height has changed due to replacement of suspension parts or tires.
      2. The installation angle of the rear television camera assembly has changed.
      Parking assist monitor system initialization
      Rear television camera assembly is replaced.


CONSTRUCTION


  1. Rear Television Camera Assembly



    1. The rear television camera assembly consists of the wide-angle lens and the Complementary Metal Oxide Semiconductor (CMOS).


      Y170689E01


      Text in Illustration 
      *a
      Wide-angle Lens
      -
      -



  2. Multi-display (Parking Assist Monitor Display)



    1. Manual Assist Mode


      1. Modes for the parking guide line function can be switched on the back camera guide line setting screen selected from the settings screen.


        Y126631

      2. The parking guide line function consists of estimated course line display mode, parking assist guide line display mode and distance guide line display mode. The initial (default) setting for perpendicular parking is estimated course line display mode.
      3. In each mode, fixed guide lines appear superimposed on a view of the area behind the vehicle. These guide lines can be used to assist the driver while backing up the vehicle.

      Y170792E01


      Text in Illustration 
      *a
      Display Mode Screen Button
      *b
      Estimated Course Line Display Mode
      *c
      Parking Assist Guide Line Display Mode
      *d
      Distance Guide Line Display Mode
      *e
      The illustrations shown are examples only. The illustrations may differ from the actual vehicle screens.
      -
      -

      1. A description of the estimated guide line display is provided in the following diagram.


        Y170690E01


        Item
        Description
        (1)
        Distance Guide Line (Yellow)
        Moves together with estimated guide lines in sync with the steering wheel. The center of the line indicates a position on the ground about 1.0 m (3.0 ft.) behind the rear bumper.
        (2)
        Distance Guide Line (Red)
        Moves together with estimated guide lines in sync with the steering wheel. The center of the line indicates a position on the ground about 0.5 m (1.5 ft.) behind the rear bumper.
        (3)
        Distance Guide Line (Blue)
        Indicates a position on the ground about 0.5 m (1.5 ft.) behind the rear bumper.
        (4)
        Vehicle Width Guide Line (Blue)
        Indicates the estimated vehicle width.
        (5)
        Estimated Guide Line (Yellow)
        Moves in sync with the steering wheel to indicate the estimated reverse course of the vehicle.
        (6)
        Clearance Sonar Icon
        If an obstacle is detected when the LEXUS parking assist-sensor system is activated, the approximate distance between he vehicle and the obstacle is displayed.
        (7)
        Warning Message Display Area
        Area where warning messages are displayed.

      1. A description of the parking guide line mode display is provided in the following diagram.


        Y170691E01


        Item
        Description
        (1)
        Distance Guide Line (Red)
        Indicates a position on the ground about 0.5 m (1.5 ft.) behind the rear bumper.
        (2)
        Vehicle Width Guide Line (Blue)
        Indicates the estimated vehicle width.
        (3)
        Parking Assist Guide Line (Blue)
        Indicates the path the vehicle will follow if the driver turns the steering wheel fully.
        (4)
        Clearance Sonar Icon
        If an obstacle is detected when the LEXUS parking assist-sensor system is activated, the approximate distance between he vehicle and the obstacle is displayed.
        (5)
        Warning Message Display Area
        Area where warning messages are displayed.

      1. A description of the guide line deletion mode display is provided in the following diagram.


        Y170692E01


        Item
        Description
        (1)
        Distance Guide Line (Red)
        Indicates a position on the ground about 0.5 m (1.5 ft.) behind the rear bumper.
        (2)
        Clearance Sonar Icon
        If an obstacle is detected when the LEXUS parking assist-sensor system is activated, the approximate distance between he vehicle and the obstacle is displayed.
        (3)
        Warning Message Display Area
        Area where warning messages are displayed.


OPERATION
  1. Estimated Course Line Display Mode (Perpendicular Parking)

    1. To use estimated guide line mode in manual assist when parking the vehicle in a parking space, perform the following procedure:

      1. Move the shift lever to R.

      2. An image appears on the display panel as illustrated below.


        Y169195


      3. Turn the steering wheel so that the estimated guide lines are within the parking space, and back up carefully.


        Y169196

      4. When the rear of the vehicle is within the parking space, turn the steering wheel in order to equalize the gap between the left and right sides of the vehicle width extension lines and the painted lines of the parking space.

      5. When the vehicle width extension guide lines and the painted lines of the parking space are parallel, straighten the steering wheel and then carefully back up until the entire vehicle is within the parking space.


        Y169197

  2. Parking Assist Guide Line Display Mode (Perpendicular Parking)

    1. To use parking guide line mode in manual assist when parking the vehicle in a parking space, perform the following procedure:

      1. Move the shift lever to R.

      2. An image appears on the multi-display as illustrated below.


        Y169198

      3. Back up the vehicle and stop at the position in which the parking guide line comes in contact with the left side of the intended parking position.

      4. Turn the steering wheel fully to the right and back up the vehicle.


        Y169199

      5. Continue backing up the vehicle until the vehicle is parallel to the painted lines.

      6. Once the vehicle is parallel, aim the steering wheel straight ahead and back up the vehicle to the target stop position.


        Y169200


FAIL-SAFE
  1. The table below indicates the malfunction detection items for the components in this system.

    Malfunctioning Parts
    Detection Item
    Function
    Rear Television Camera Assembly
    Camera malfunction signal is detected
    Stops system operation and displays a dark screen
    Steering Sensor
    1. Sensor malfunction is detected
    2. Sensor open circuit signal is detected
    3. Communication malfunction between steering sensor and rear television camera assembly
    Stops system operation
    Neutral steering point correction incomplete signal is detected
    Radio and Display Receiver Assembly
    Malfunction of radio and display receiver assembly


DIAGNOSIS
  1. The radio and display receiver assembly is equipped with a diagnosis function which can display a diagnosis menu for the parking assist monitor system. The method for entering the diagnosis menu screen is the same as the method used for the multi-display. For details, refer to the Repair Manual.