DRIVE SHAFT SYSTEM > GENERAL



OUTLINE


  1. The front drive shaft assembly for all models uses a tripod type Constant Velocity (CV) joint on the differential side, and a Rzeppa type CV joint on the wheel side.


    X133231E01


    Text in Illustration 
    *A
    Models with 2AR-FE Engine (For TMC Made)
    -
    -
    *1
    Rzeppa Type CV Joint
    *2
    Tripod Type CV Joint
    *3
    Front Drive Shaft Assembly LH
    *4
    Front Drive Shaft Assembly RH
    V100135
    Wheel Side
    V100136
    Differential Side

    X133232E01


    Text in Illustration 
    *A
    Models with 2AR-FE or 6AR-FSE Engine (For TMMR Made)
    -
    -
    *1
    Rzeppa Type CV Joint
    *2
    Tripod Type CV Joint
    *3
    Front Drive Shaft Assembly LH
    *4
    Front Drive Shaft Assembly RH
    V100135
    Wheel Side
    V100136
    Differential Side

    X134390E01


    Text in Illustration 
    *A
    Models with 2AR-FE Engine (For TMMK Made)
    -
    -
    *1
    Rzeppa Type CV Joint
    *2
    Tripod Type CV Joint
    *3
    Front Drive Shaft Assembly LH
    *4
    Front Drive Shaft Assembly RH
    V100135
    Wheel Side
    V100136
    Differential Side

    X133233E01


    Text in Illustration 
    *A
    Models with 2GR-FE Engine
    -
    -
    *1
    Rzeppa Type CV Joint
    *2
    Tripod Type CV Joint
    *3
    Front Drive Shaft Assembly LH
    *4
    Front Drive Shaft Assembly RH
    V100135
    Wheel Side
    V100136
    Differential Side


MAJOR DIFFERENCE
  1. The new models have been modified from the previous models as shown below:

    1. Addition of the front drive shaft assembly for TMMK made 2AR-FE engine.