CAN COMMUNICATION SYSTEM > GENERAL |
| OUTLINE |
The Controller Area Network (CAN) uses 2 different types of CAN buses:
Each CAN bus has 2 terminating resistors which are necessary for accurate judgment of communication.
The terminating resistors for each bus are located as shown in the following table.
| Speed Communication | Bus | Terminating Resistor Location |
| High-speed (HS-CAN) | CAN V Bus |
|
| CAN Sub Bus 2 |
| |
| Middle-speed (MS-CAN) | CAN Sub Bus 1 |
|
The main body ECU (multiplex network body ECU) has a gateway function and is used to transmit data between the CAN V bus and the CAN sub bus 1.
| MAJOR DIFFERENCE |
The new models have been modified from the previous models as shown below:
The telematics transceiver (data communication module) has been added.