Blocking
| - Once the user has informed the call center of the theft of the vehicle, the call center will transmit a blocking signal to the vehicle. Once the telephone transceiver assembly has received the blocking signal, it will activate the blocking. Communication between the certification ECU (smart key ECU assembly) and ECM is canceled, thus preventing the engine from starting.
- While the ignition is off, the telephone transceiver assembly activates every 12 hours*1 to calculate the vehicle location data using GPS signals. If the telephone transceiver assembly determines, based on the calculated vehicle location, that the vehicle position has changed by more than a certain amount while the ignition was off, the telephone transceiver assembly enters the autonomous blocking state. If the owner of the vehicle already subscribed to a service of the service provider, the telephone transceiver assembly sends a message to the call center via General Pocket Radio Service (GPRS)/GSM to inform them of the abnormality. However, if the owner of the vehicle is not a subscriber, it is still possible for them to subscribe to the service after the situation has occurred. After the contract is complete, the telephone transceiver assembly will receive short message service (SMS) data from the service provider to indicate that the service has started.*2
|