Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR SPOILER

REAR SPOILER > INSTALLATION

for Preparation Click here



1. INSTALL REAR SPOILER SUB-ASSEMBLY

HINT:
When installing a new rear spoiler, heat the vehicle body and rear spoiler sub-assembly using a heat light.

Heating Temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Rear Spoiler Sub-assembly
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body, rear spoiler sub-assembly excessively.

  1. Install the 2 stud bolts to the rear spoiler cover.

  1. Install 2 new gaskets to the rear spoiler cover.

  1. Install 4 new clips to the rear spoiler cover.

  1. Clean the vehicle body surface.

    1. Using a heat light, heat the vehicle body surface.

    2. Remove any remaining double-sided tape from the vehicle body.

    3. Wipe off any tape adhesive residue with cleaner.

  1. Using a heat light, heat the vehicle body and a new rear spoiler sub-assembly.

  1. Remove the release paper from the rear spoiler sub-assembly.



    B401581
  1. Engage the 4 clips.

  1. Install the rear spoiler sub-assembly with the 2 nuts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



2. INSTALL LUGGAGE COMPARTMENT DOOR COVER


    B380679
  1. Install the luggage compartment door cover with the 13 clips.