Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROCKER PANEL MOULDING

ROCKER PANEL MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE FRONT ROCKER PANEL MOULDING END COVER


    B282067
  1. Remove the 2 screws and front rocker panel moulding end cover.



2. REMOVE ROCKER PANEL MOULDING


  1. Apply protective tape around the rocker panel moulding and door as shown in the illustration.


    B382676


    Text in Illustration 
    V100155
    Protective Tape
    -
    -



    B382677
  1. Remove the 2 screws and grommet.



    B382678
  1. Remove the screw.



    B382679
  1. Using a clip remover, remove the 7 clips.



    B382680
  1. Remove the screw.



    B382681
  1. Disengage the 10 clips and remove the rocker panel moulding.

  1. Remove the 10 clips from the rocker panel moulding.