Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type)

NAVIGATION SYSTEM (for Navigation Receiver Type) > Disc cannot be Inserted or is Ejected Right After Insertion

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK IF A PROPER DISC IS INSERTED
  1. Make sure that the disc is an audio disc or a disc with an MP3, WMA or AAC files, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.

    OK:
    Normal disc.

    HINT:
    1. Translucent or uniquely-shaped CDs cannot be played.
    2. CDs and DVDs with adhesive paper labels should not be played.
    3. Commercial audio CDs and DVDs can be played.
    4. CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.
    5. MP3, WMA and AAC files on CD-ROMs, CD-Rs and CD-RWs can be played.
    6. For details on playable CDs and DVDs, refer to Owner's Manual.



NG
CHANGE CD
OK


2.CHECK THAT DISC IS INSERTED PROPERLY
  1. Check if the disc is inserted upside down.

    OK:
    Disc is properly inserted.



NG
INSERT DISC PROPERLY
OK


3.CLEAN DISC AND RECHECK


    I100151
  1. Clean the disc by wiping it clean with a soft cloth from the inside to the outside in a radial direction.

    OK:
    Malfunction disappears.

    NOTICE:
    Do not use a conventional record cleaner or anti-static preservative.



NG
Go to step 4
OK

END (DISC WAS DIRTY) 

4.REPLACE DISC AND RECHECK
  1. Replace the disc with a known good one and check that the malfunction disappears.

    OK:
    Malfunction disappears.

    Result:
    Result
    Proceed to
    OK
    A
    NG (for TMMK Made)
    B
    NG (for TMC Made)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (for TMMK Made) (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (for TMC Made) (Click here)
A

END (DISC WAS FAULTY)