Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type)

NAVIGATION SYSTEM (for Radio and Display Type) > CD cannot be Inserted or is Ejected Right After Insertion

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK IF A PROPER CD IS INSERTED
  1. Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC files, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.

    OK:
    Normal CD.

    HINT:
    1. Translucent or uniquely-shaped CDs cannot be played.
    2. CDs with adhesive paper labels should not be played.
    3. Commercial audio CDs can be played.
    4. CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.
    5. MP3, WMA and AAC files on CD-ROMs, CD-Rs and CD-RWs can be played.
    6. For details on playable CDs, refer to Owner's Manual.



NG
CHANGE CD
OK


2.CHECK THAT CD IS INSERTED PROPERLY
  1. Check the CD is inserted upside down.

    OK:
    CD is properly inserted.



NG
INSERT CD PROPERLY
OK


3.CLEAN CD AND RECHECK


    I100151
  1. Clean the CD by wiping it clean with a soft cloth from the inside to the outside in a radial direction.

    OK:
    Malfunction disappears.

    NOTICE:
    Do not use a conventional record cleaner or anti-static preservative.



NG
Go to step 4
OK

END (CD WAS DIRTY) 

4.REPLACE CD AND RECHECK
  1. Replace the CD with a new or known good one and check that the malfunction disappears.

    OK:
    Malfunction disappears.



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK

END (CD WAS FAULTY)