FRONT BRAKE > DISASSEMBLY |
| 1. REMOVE CYLINDER BOOT (for TMC, TMMR Made) |
![]() |
Using a screwdriver with its tip wrapped with vinyl tape, remove the front disc brake piston set ring and cylinder boot from the disc brake cylinder assembly.
| *1 | Vinyl Tape |
| 2. REMOVE FRONT DISC BRAKE PISTON |
Place a piece of cloth between the front disc brake piston and front disc brake cylinder.
![]() |
Apply compressed air to remove the front disc brake piston from the front disc brake cylinder.
| 3. REMOVE CYLINDER BOOT (for TMMK Made) |
![]() |
Using a screwdriver with its tip wrapped with vinyl tape, remove the cylinder boot from the front disc brake cylinder.
| *1 | Vinyl Tape |
| 4. REMOVE PISTON SEAL |
![]() |
Using a screwdriver with its tip wrapped with vinyl tape, remove the piston seal from the front disc brake cylinder.
| *1 | Vinyl Tape |
| 5. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP |
| 6. REMOVE FRONT DISC BRAKE BLEEDER PLUG |