SFI SYSTEM > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE |
Check and ensure the following conditions:
Battery voltage is 11 V or higher.
Throttle valve is fully closed.
Shift lever is in P or N.
A/C switch is off.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.
Switch the ECM from normal mode to check mode.
![]() |
Check that the MIL flashes as shown in the illustration.
Start the engine.
Check that the MIL turns off.
Simulate the conditions of the malfunction described by the customer.
Check the DTCs and freeze frame data using the tester.