Home › Vehicle Exterior › LIGHTING (EXT) › AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)

AFS (ADAPTIVE FRONT-LIGHTING SYSTEM) > TERMINALS OF ECU

for Preparation Click here



CHECK AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY)


  1. Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.


    E133226E21

  2. Measure the resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    A35-22 (E1) - Body ground
    W-B - Body ground
    AFS ECU (headlight swivel ECU assembly) ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    A35-14 (IGS) - Body ground
    V - Body ground
    Swivel motor power supply
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    A35-15 (IG) - Body ground
    LG - Body ground
    AFS ECU (headlight swivel ECU assembly) power supply
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    If the result is not as specified, there may be a malfunction in the wire harness.

  4. Reconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.

  5. Measure the resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    A35-21 (SGR) - A35-22 (E1)
    G - W-B
    Rear height control sensor ground
    Always
    Below 1 Ω
    A35-23 (SMGL) - A35-22 (E1)
    V - W-B
    Swivel motor LH ground
    Always
    Below 1 Ω
    A35-24 (SMGR) - A35-22 (E1)
    R - W-B
    Swivel motor RH ground
    Always
    Below 1 Ω
    A35-27 (LH-) - A35-22 (E1)
    GR - W-B
    Leveling motor LH ground
    Always
    Below 1 Ω
    A35-28 (RH-) - A35-22 (E1)
    Y - W-B
    Leveling motor RH ground
    Always
    Below 1 Ω
    If the result is not as specified, the AFS ECU (headlight swivel ECU assembly) may have a malfunction.

  6. Measure the voltage or check for pulses according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    A35-1 (SMBL) - A35-22 (E1)
    GR - W-B
    Swivel motor LH power supply
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 16 V
    A35-2 (SMBR) - A35-22 (E1)
    BE - W-B
    Swivel motor RH power supply
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 16 V
    A35-3 (LH+) - A35-22 (E1)
    Y - W-B
    Leveling motor LH power supply
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 16 V
    A35-4 (RH+) - A35-22 (E1)
    R - W-B
    Leveling motor RH power supply
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 16 V
    A35-7 (SPDL) - A35-22 (E1)
    SB - W-B
    Initialization signal
    Ignition switch ON, terminals LVL and GND of DLC3 connected
    Below 1 V
    Ignition switch ON, terminals LVL and GND of DLC3 not connected
    4.5 to 5.5 V
    A35-10 (SMR) - A35-22 (E1)
    L - W-B
    Swivel motor RH LIN communication
    Ignition switch off
    Below 1 V
    Ignition switch ON
    Pulse generation
    A35-11 (RHE) - A35-22 (E1)
    LG - W-B
    Leveling motor RH LIN communication
    Ignition switch off
    Below 1 V
    Ignition switch ON
    Pulse generation
    A35-12 (MPX1) - A35-22 (E1)
    B - W-B
    CAN communication
    Ignition switch off
    Below 1 V
    Ignition switch ON
    Pulse generation
    A35-13 (MPX2) - A35-22 (E1)
    W - W-B
    CAN communication
    Ignition switch off
    Below 1 V
    Ignition switch ON
    Pulse generation
    A35-18 (SBR) - A35-21 (SGR)
    B - G
    Rear height control sensor power supply
    Ignition switch off
    Below 1 V
    Ignition switch ON
    4.5 to 5.5 V
    A35-19 (SHRL) - A35-21 (SGR)
    L - G
    Rear height control sensor signal
    Ignition switch off
    Below 1 V
    Ignition switch ON
    1 to 4 V
    A35-29 (SML) - A35-22 (E1)
    P - W-B
    Swivel motor LH LIN communication
    Ignition switch off
    Below 1 V
    Ignition switch ON
    Pulse generation
    A35-30 (LHE) - A35-22 (E1)
    W - W-B
    Leveling motor LH LIN communication
    Ignition switch off
    Below 1 V
    Ignition switch ON
    Pulse generation
    If the result is not as specified, the AFS ECU (headlight swivel ECU assembly) may have a malfunction.