AUTOMATIC HIGH BEAM SYSTEM > SYSTEM DESCRIPTION |
| AUTOMATIC HIGH BEAM SYSTEM |
General
The automatic high beam system enhances the illumination of the area to the front of the vehicle to improve visibility for the driver. It works by detecting light from the front using the camera built into the inner rear view mirror assembly and turning the high beams of the headlights on or off automatically.
Function of Main Components
| Component | Outline | |
| Inner Rear View Mirror Assembly (Automatic High Beam Sensor) | Determines when to turn the high beams on and off after identifying the lights of oncoming vehicles, preceding vehicles and other lights from the picture information of its camera sensor. Then, it sends high beam request signals to the main body ECU (multiplex network body ECU) via CAN communication. | |
| Airbag Sensor Assembly (Yaw Rate Sensor) | Outputs yaw rate information to the main body ECU (multiplex network body ECU). | |
| Brake Actuator Assembly (Skid Control ECU) | Outputs information about the speed of the right front wheel. This information is used by the automatic high beam sensor (inner rear view mirror assembly) to turn the high beams on and off. | |
| Combination Meter Assembly | Turns on the automatic high beam indicator light and displays a message on the multi-information display based on an indicator illumination request signal from the main body ECU (multiplex network body ECU).
| |
| Main Body ECU (Multiplex Network Body ECU) |
| |
| ECM | Outputs a signal to indicate that the shift lever is in R. Based on this signal, the automatic high beam sensor (inner rear view mirror assembly) turns the high beams off. | |
Basic Function
When all of the following conditions are met, the automatic high beam system is activated and the automatic high beam indicator light turns on:
When all of the following conditions are met, high beams automatically turn on after a short delay:
When any of the following conditions are met, the high beams automatically turn off after a short delay:
When any of the following conditions are met, the automatic high beam system will be canceled and the indicator light will turn off.
High beam control limitations: