Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM

AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
  1. Automatic headlight beam level control system data and Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.


CHECK DLC3
  1. Check the DLC3 (Click here).


INSPECT BATTERY VOLTAGE
  1. Measure the battery voltage.

    Standard Voltage:
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery.


DIAGNOSIS SYSTEM


  1. If the automatic headlight beam level control system malfunctions, "Check Headlight System"*1 or "Check Headlight Leveling System"*2 is displayed on the multi-information display.


    E314468E01


    Text in Illustration 
    *A
    for TMC, TMMR Made
    *B
    for TMMK Made

    HINT:
    1. In this case, the headlight leveling ECU assembly stores DTCs (Click here).
    2. When the system returns to normal, "Check Headlight System"*1 or "Check Headlight Leveling System"*2 is no longer displayed on the multi-information display.

    1. *1: for TMC, TMMR Made
    2. *2: for TMMK Made