Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM

AUTOMATIC HIGH BEAM SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
  1. Automatic high beam system data and Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the GTS to check for malfunctions and perform repairs.


CHECK DLC3
  1. Check the DLC3 (Click here).


INSPECT BATTERY VOLTAGE
  1. Measure the battery voltage.

    Standard Voltage:
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery.


DIAGNOSIS SYSTEM


    E302777E01
  1. If the automatic high beam system malfunctions, the automatic high beam indicator light turns off and "Check Headlight System" is displayed on the multi-information display.

    HINT:
    1. In this case, the main body ECU (multiplex network body ECU) stores DTCs (Click here).
    2. When the system returns to normal, "Check Headlight System" is no longer displayed on the multi-information display.

    Text in Illustration 
    *a
    Automatic High Beam Indicator Light
    *b
    Multi-information Display