AFS (ADAPTIVE FRONT-LIGHTING SYSTEM) > DATA LIST / ACTIVE TEST |
| DATA LIST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / AFS / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| AFS OFF Switch | AFS OFF switch signal/ON or OFF | ON: AFS off OFF: AFS on | - |
| Traveling Direction | Traveling Direction/Not Fwd or Fwd | Not Fwd: Shift lever in R or N Fwd: Shift lever not in R or N | - |
| Headlight Low Beam State | Low beam headlight state/ON or OFF | ON: Low beam headlights on OFF: Low beam headlights off | - |
| Headlight High Beam State | High beam headlight state/ON or OFF | ON: High beam headlights on OFF: High beam headlights off | - |
| Engine | Engine condition/Run or Stop | Run: Engine running Stop: Engine stopped | - |
| +B | IG power supply voltage value/0.00 to 19.75 V | 11 to 14 V | - |
| Height Sens Pw Supply Val | Height control sensor power supply value/0.00 to 6.25 V | Approx. 5 V | - |
| Rr Height Sens Signal Val | Rear height control sensor signal value/0.00 to 5.00 V | Approx. 2.5 V (When vehicle is level) | Value changes according to vehicle height |
| Steering Sens Signal | Steering angle sensor signal value/-384.0 deg to 382.5 deg | Approx. 0 deg (When steering wheel is straight) | Value changes according to steering wheel position |
| Steering Sens Center Pos | Steering angle sensor center position/-3072.0 deg to 3070.5 deg | Condition can be displayed | - |
| FR Wheel Speed | Front right wheel speed/0.00 to 327.67 km/h (203.61 mph) | Condition can be displayed | - |
| FL Wheel Speed | Front left wheel speed/0.00 to 327.67 km/h (203.61 mph) | Condition can be displayed | - |
| Vehicle Speed | Vehicle speed/0.00 to 327.67 km/h (203.61 mph) | Condition can be displayed | - |
| Rear Height Adjust Valid Flag | Rear height adjustment range/Valid or Invalid | Condition can be displayed | - |
| Init Writing Count | Number of times for initialization/0 to 255 | Condition can be displayed | - |
| Sensor Initialization Hist | Sensor Initialization History/not comp, 10%, 25%, 50%, 75%, 100% or complied | Condition can be displayed | - |
| L Swivel Target Step | Swivel motor LH target step value/0 to 400 step | 34 to 286 step | - |
| L Swivel Current Step | Swivel motor LH current step value/0 to 400 step | 34 to 286 step | - |
| R Swivel Target Step | Swivel motor RH target step value/0 to 400 step | 8 to 185 step | - |
| R Swivel Current Step | Swivel motor RH current step value/0 to 400 step | 8 to 185 step | - |
| LR Leveling Target Step | Leveling motor LH and RH target step value/0 to 300 step | 5 to 247 step | - |
| L Leveling Current Step | Leveling motor LH current step value/0 to 300 step | 5 to 247 step | - |
| R Leveling Current Step | Leveling motor RH current step value/0 to 300 step | 5 to 247 step | - |
| Number Of Trouble Codes | Number of trouble codes/0 to 255 | Condition can be displayed | - |
| ACTIVE TEST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / AFS / Active Test.
Perform the Active Test according to the display on the intelligent tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Drive The Leveling Motor UP*1 | Leveling motor upward operation | ON/OFF | ON: Moves up OFF: Stops |
| Drive The Leveling Motor DOWN*1 | Leveling motor downward operation | ON/OFF | ON: Moves down OFF: Stops |
| Drive Swivel Motor LH LEFT*1 | Swivel motor LH left direction rotation | ON/OFF | ON: Moves left OFF: Stops |
| Drive Swivel Motor LH RIGHT*1 | Swivel motor LH right direction rotation | ON/OFF | ON: Moves right OFF: Stops |
| Drive Swivel Motor RH LEFT*1 | Swivel motor RH left direction rotation | ON/OFF | ON: Moves left OFF: Stops |
| Drive Swivel Motor RH RIGHT*1 | Swivel motor RH right direction rotation | ON/OFF | ON: Moves right OFF: Stops |
| AFS OFF Indicator | AFS OFF indicator | ON/OFF | - |