Home › Engine / Hybrid System ยท 2GR-FE › INTAKE / EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. REMOVE TAIL EXHAUST PIPE ASSEMBLY LH


    A255356
  1. Remove the 2 nuts.

  1. Remove the tail exhaust pipe assembly LH from the 2 exhaust pipe supports.

  1. Remove the gasket from the center exhaust pipe assembly.



2. REMOVE TAIL EXHAUST PIPE ASSEMBLY


    A255355
  1. Remove the 2 nuts.

  1. Remove the tail exhaust pipe assembly from the 3 exhaust pipe supports.

  1. Remove the gasket from the center exhaust pipe assembly.



3. REMOVE EXHAUST PIPE DAMPER


    A255358
  1. Remove the 2 bolts and exhaust pipe damper.



4. REMOVE CENTER EXHAUST PIPE ASSEMBLY


    A255359
  1. Remove the 2 bolts and 2 nuts.

  1. Remove the center exhaust pipe assembly from the 2 exhaust pipe supports.

  1. Remove the gasket from the front exhaust pipe assembly.



5. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


6. REMOVE ENGINE UNDER COVER RH


7. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Front Side)


    A255354
  1. Remove the 2 nuts and No. 1 exhaust pipe support bracket (for Front Side).



8. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A255349
  1. Disconnect the 2 wire harnesses from the clamp.

  1. Disconnect the 2 heated oxygen sensor connectors.



    A255360
  1. Remove the 2 bolts and 2 nuts.

  1. Remove the front exhaust pipe assembly from the No. 1 exhaust pipe support bracket (for Rear Side).

  1. Remove the 2 gaskets from the front exhaust pipe assembly.



9. REMOVE HEATED OXYGEN SENSOR (for Bank 1)


    A255017E01
  1. Using SST, remove the heated oxygen sensor from the front exhaust pipe sub-assembly.

    SST
    09224-00011  



10. REMOVE HEATED OXYGEN SENSOR (for Bank 2)


    A255019E01
  1. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

    SST
    09224-00011  



11. REMOVE TAIL EXHAUST PIPE BAFFLE SUB-ASSEMBLY


    A254710
  1. Remove the 2 tail exhaust pipe baffle sub-assemblies.