Home › Engine / Hybrid System ยท 6AR-FSE › INTAKE / EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. REMOVE HEATED OXYGEN SENSOR
(Click here)


2. REMOVE TAIL EXHAUST PIPE ASSEMBLY


    A261041
  1. Remove the 2 bolts, 2 compression springs and tail exhaust pipe assembly from the center exhaust pipe assembly.

  1. Disconnect the tail exhaust pipe assembly from the 3 exhaust pipe supports.

  1. Remove the exhaust pipe gasket from the center exhaust pipe assembly.



3. REMOVE CENTER EXHAUST PIPE ASSEMBLY


    A254706
  1. Remove the 2 nuts and center exhaust pipe assembly from the front exhaust pipe assembly (TWC: Rear Catalyst).

  1. Disconnect the center exhaust pipe assembly from the exhaust pipe support.

  1. Remove the exhaust pipe gasket from the front exhaust pipe assembly (TWC: Rear Catalyst).



4. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)


    A258964
  1. Remove the 2 bolts, 2 compression springs and front exhaust pipe assembly (TWC: Rear Catalyst) from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).

  1. Disconnect the front exhaust pipe assembly (TWC: Rear Catalyst) from the exhaust pipe support.

  1. Remove the exhaust pipe gasket from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).