Home › Engine / Hybrid System ยท 2AR-FE › EMISSION CONTROL › CANISTER (for TMMK Made)

CANISTER (for TMMK Made) > INSPECTION

for Preparation Click here



1. CHECK CANISTER (FUEL SUCTION PLATE SUB-ASSEMBLY)
  1. Visually check the canister (fuel suction plate sub-assembly).

    1. Visually check the canister (fuel suction plate sub-assembly) for cracks or damage.
      If cracks or damage are found, replace the canister (fuel suction plate sub-assembly).



  1. Inspect the ventilation of the canister (fuel suction plate sub-assembly).



      A310375E01
    1. Apply compressed air to the port (A) and check that the air flows from the port (B).
      Text in Illustration 
      *a
      Port (A)
      *b
      Port (B)
      *c
      Air

      OK:
      Air flows from the port (B).



  1. Inspect the check valve.



      A310376E01
    1. Close the port (A), apply compressed air to the port (B).
      Text in Illustration 
      *a
      Port (A)
      *b
      Port (B)
      *c
      Air

      OK:
      Air does not flow at first. By gradually increasing the pressure, air flows when the pressure in the port reaches a certain level.



    2. A310377E01
    3. Using a vacuum pump, apply vacuum to the port (B) with the port (A) closed.
      Text in Illustration 
      *a
      Port (A)
      *b
      Port (B)
      *c
      Vacuum Pump

      OK:
      The vacuum is maintained at first. By gradually increasing the vacuum, air flows and the level of vacuum is maintained after the vacuum reaches a certain level.