Home › Engine / Hybrid System ยท 2AR-FE › FUEL › FUEL PUMP (for TMMK Made)

FUEL PUMP (for TMMK Made) > REASSEMBLY

for Preparation Click here



1. INSTALL FUEL PUMP WITH FILTER ASSEMBLY

HINT:
Perform "Inspection After Repair" after replacing the fuel pump with filter assembly (Click here).



    A288172E01
  1. Apply gasoline to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump with filter assembly.
    Text in Illustration 
    *1
    O-ring
    *2
    Fuel Pump Spacer

  1. Engage the 5 claws of the fuel pump with filter assembly.

    NOTICE:
    1. Make sure that the O-ring is not cut or pinched during installation.
    2. Engage the claws securely.
    3. Do not remove the suction filter from the fuel pump with filter sub-assembly.



    A288173
  1. Engage the 2 claws to install the No. 1 fuel suction support.

  1. Connect the fuel pump harness connector to install the fuel pump harness to the fuel pump with filter assembly.

  1. Engage the 2 claws and install the fuel filter and the fuel pump with filter assembly to the fuel sub-tank.

    NOTICE:
    Do not apply excessive force to the tube or the No. 1 fuel suction support.



    A347579
  1. Engage the claw and connect the fuel pump filter hose while aligning it with the installation position of the fuel sub-tank.

  1. Connect the fuel pump harness connector.



2. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A283914E01
  1. Slide the fuel sender gauge assembly downward and engage the claw (A) to install the fuel sender gauge assembly.

  1. Connect the fuel sender gauge assembly connector.

  1. Install the 2 wire harness protectors to the wire harness.

    NOTICE:
    Do not damage the wire harness.

  1. Engage the 2 wire harness clamps.

    NOTICE:
    Do not damage the wire harness.