BRAKE FLUID > BLEEDING |
| 1. FILL RESERVOIR WITH BRAKE FLUID |
![]() |
Remove the brake master cylinder reservoir filler cap.
Fill the reservoir with brake fluid.
| 2. BLEED BRAKE MASTER CYLINDER |
![]() |
Using a union nut wrench, disconnect the 2 brake lines from the brake master cylinder sub-assembly.
![]() |
Slowly depress the brake pedal and hold it.*1
![]() |
Cover the 2 outer holes with fingers, and release the brake pedal.*2
Repeat steps *1 and *2, 3 or 4 times.
![]() |
Using a union nut wrench, connect the 2 brake lines to the brake master cylinder sub-assembly.
| *a | Torque Wrench Fulcrum Length |
| 3. BLEED BRAKE LINE |
Connect a vinyl tube to the bleeder plug.
Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.*1
When fluid stops coming out, tighten the bleeder plug, and release the brake pedal.*2
Repeat steps *1 and *2 until all the air in the brake fluid is completely bled out and a new brake fluid comes out.
Tighten the bleeder plug completely.
Repeat the above steps to replace the brake fluid of the brake lines for each wheel.
| 4. INSPECT FOR BRAKE FLUID LEAK |
| 5. INSPECT BRAKE FLUID LEVEL IN RESERVOIR |
![]() |
Check the fluid level.
| *A | for TMC, TMMR Made |
| *B | for TMMK Made |
| *a | MAX Line |
| *b | MIN Line |