STEERING ANGLE SENSOR > INSTALLATION |
| 1. INSPECT SPIRAL CABLE SUB-ASSEMBLY (for TMMK Made) |
![]() |
Check if the spiral cable sub-assembly is centered.
![]() | Colored Part |
If the spiral cable sub-assembly is not centered, center it.
![]() |
While pushing on the interlock indicated in the illustration, rotate the spiral cable sub-assembly counterclockwise slowly by hand until it stops.
![]() | Interlock |
![]() |
While pushing on the interlock indicated in the illustration, rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to the position where the colored part shown in the illustration can be seen.
![]() | Colored Part |
![]() | Interlock |
| 2. INSPECT SPIRAL CABLE SUB-ASSEMBLY (for TMC, TMMR Made) |
![]() |
Check if the spiral cable sub-assembly is centered.
![]() | Colored Part |
If the spiral cable sub-assembly is not centered, center it.
If the cable cannot be centered, it is possible that the spiral cable sub-assembly is broken. Replace the spiral cable with sensor sub-assembly with a new one.
![]() |
While pushing on the interlock indicated in the illustration, rotate the spiral cable sub-assembly counterclockwise slowly by hand until it stops.
![]() | Interlock |
![]() |
Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to the position where the colored part shown in the illustration is visible.
![]() | Colored Part |
![]() | Interlock |
| 3. INSTALL STEERING SENSOR |
![]() |
Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.
| *1 | Lock Pin |
| *a | Guide |
| *b | Pin |
![]() |
Remove the lock pin from the steering sensor.
| 4. ALIGN FRONT WHEELS TO FACE STRAIGHT AHEAD |
| 5. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |