Home › Engine / Hybrid System ยท CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > FAIL-SAFE CHART

for Preparation Click here


HINT:
If the following conditions are detected while the cruise control system is controlling vehicle speed, the system clears the vehicle speed stored in the ECM and cancels cruise control system control of vehicle speed.


Vehicle Condition
Auto Cancel Condition
Re-operation Condition
Cruise control indicator goes out and a warning message is displayed
  1. Open or short in stop light switch circuit
  2. Problem with vehicle speed signal
Cruise control system is turned off and back on again using the cruise control switch (ON-OFF button).
  1. Problem with stop light switch input circuit
  2. Problem with cruise control switch cancel circuit
  3. Cruise control active signal inconsistency between Main-CPU and Sub-CPU (DTC P160700 is output)
Ignition switch is turned off and back to ON again.
Cruise control indicator remains illuminated (Cruise control system control of vehicle speed is canceled)
  1. Vehicle speed is lower than low speed limit (approx. 40 km/h (25 mph)) while driving with cruise control system controlling vehicle speed
  2. VSC system operates while driving with cruise control system controlling vehicle speed
  3. TRC system operates for a certain period of time while driving with cruise control system controlling vehicle speed.
Cruise control switch is pushed to +/RES
Vehicle speed is lower than stored speed by approximately 16 km/h (10 mph) or more
Cruise control switch is pushed to -/SET
Cruise control indicator goes out
Problem with throttle position sensor or motor
Cruise control system is turned off and back on again using the cruise control switch (ON-OFF button).