DTC P0617 Starter Relay Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0617 | Conditions (a), (b) and (c) are met, and a positive (+B) battery voltage of 10.5 V or higher is applied to the ECM for 20 seconds (1 trip detection logic):
|
|
| Required Sensors/Components (Main) | Starter relay (ST) Park/Neutral position switch assembly Ignition switch assembly Certification ECU (smart key ECU assembly) |
| Required Sensors/Components (Related) | Vehicle speed sensor Crankshaft position sensor |
| Frequency of Operation | Continuous |
| Vehicle speed | 20 km/h (12.43 mph) or more |
| Engine speed | 1000 rpm or higher |
| Starter signal | On |

| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|


| 1.READ VALUE USING GTS (STARTER SIGNAL) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Starter Signal.
Check the value displayed on the GTS when the vehicle is driven at 20 km/h (12.4 mph) or more.
| Condition | Starter Signal | Proceed to |
| Driving at 20 km/h (12.4 mph) or more | OFF | A |
| ON | B |
|
| ||||
| A | ||
| ||
| 2.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Inspect the park/neutral position switch assembly (Click here).
|
| ||||
| OK | |
| 3.REPAIR OR REPLACE HARNESS OR CONNECTOR (STA SIGNAL CIRCUIT) |
Repair or replace harness or connector (starter signal circuit).
| NEXT | |
| 4.CHECK WHETHER DTC OUTPUT RECURS (DTC P0617) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear the DTCs (Click here).
Turn the ignition switch off and wait for at least 30 seconds.
Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0617 is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||