SPIRAL CABLE (for TMMK Made) > INSTALLATION |
| 1. ALIGN FRONT WHEELS TO FACE STRAIGHT AHEAD |
| 2. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
Check that the engine switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
Engage the 3 claws to install the spiral cable with sensor sub-assembly.
Connect each connector.
| 3. INSTALL UPPER STEERING COLUMN COVER |
Engage the 2 claws to install the upper steering column cover.
Engage the 4 clips and 2 guides to the upper steering column cover.
| 4. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Engage the 2 claws to install the lower steering column cover.
![]() |
Install the 2 screws.
![]() |
Engage the claw.
| 5. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
Check that the engine switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Check if the spiral cable with sensor sub-assembly is centered.
![]() | Colored Part |
If the spiral cable with sensor sub-assembly is not centered, center it.
![]() |
While pushing on the interlock indicated in the illustration, rotate the spiral cable with sensor sub-assembly counterclockwise slowly by hand until it stops.
![]() | Interlock |
![]() |
Rotate the spiral cable with sensor sub-assembly clockwise approximately 2.5 turns to the position where the colored part shown in the illustration is visible.
![]() | Colored Part |
![]() | Interlock |
| 6. INSTALL STEERING WHEEL ASSEMBLY |