Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE (for TMMK Made)

SPIRAL CABLE (for TMMK Made) > REMOVAL

for Preparation Click here



1. REMOVE STEERING WHEEL ASSEMBLY
(Click here)


2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD


3. INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY


    B279793
  1. Check the colored part as shown in the illustration.
    Text in Illustration 
    V100144
    Colored Part
    If the colored part shown in the illustration cannot be confirmed, it is possible that the spiral cable with sensor sub-assembly is broken. Replace the spiral cable with sensor sub-assembly with a new one.



4. REMOVE LOWER STEERING COLUMN COVER


    C241154
  1. Remove the 2 screws.



    C241155
  1. Push the right and left sides of the lower steering column cover, and disengage the 2 claws.



    C241156
  1. Insert a finger into the opening of the tilt lever of the lower steering column cover to disengage the claw and remove the lower steering column cover.



5. REMOVE UPPER STEERING COLUMN COVER


    C241158
  1. Disengage the 4 clips and 2 guides from the upper steering column cover.



    C241157
  1. Disengage the 2 claws to remove the upper steering column cover.



6. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

NOTICE:
  1. Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).
  2. Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the battery connected and the engine switch on (IG).
  3. Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

  1. Check that the engine switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

  1. Check that the front wheels are facing straight ahead.



    B279735E01
  1. Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.
    Text in Illustration 
    *a
    Slider

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.

  1. Disconnect the other connector from the spiral cable with sensor sub-assembly.



    B279736
  1. Disengage the 3 claws to remove the spiral cable with sensor sub-assembly.