REAR AIRBAG SENSOR (for TMMK Made) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE REAR SEAT CUSHION ASSEMBLY |
![]() |
Lift up the front edge of the rear seat cushion assembly as shown in the illustration and disengage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly from the 2 rear seat cushion lock hooks.
| a | 100 mm (3.94 in.) or less |
Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly and remove the rear seat cushion assembly.
| 4. REMOVE REAR SEAT CUSHION LOCK HOOK |
![]() |
Disengage the 2 claws to remove the rear seat cushion lock hook as shown in the illustration.
| 5. REMOVE REAR SIDE SEATBACK ASSEMBLY |
Disconnect the rear seat outer belt assembly from the rear seat shoulder belt guide.
Disconnect the connector.
![]() |
Remove the 2 bolts.
Disengage the hook and remove the rear side seatback assembly LH.
| 6. REMOVE SIDE NO. 2 AIRBAG SENSOR ASSEMBLY |
Check that the engine switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Disconnect the connector from the side No. 2 airbag sensor assembly.
Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

| *1 | White Housing Lock | *2 | Yellow CPA |
| *a | Slide | *b | Push |
Push down the white housing lock again and disconnect the connector.
Remove the bolt and side No. 2 airbag sensor assembly from the vehicle body.
After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

| *a | Correct | *b | Incorrect |