KNEE AIRBAG ASSEMBLY (for TMMK Made Front Passenger Side) > INSTALLATION |
| 1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY |
Check that the engine switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.
| *1 | Airbag Connector |
| *2 | Airbag Connector Lock |
Push in the lock to install the airbag connector.
Temporarily install the lower No. 2 instrument panel airbag assembly with the 3 claws.
Install the 3 bolts.
| 2. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Connect the connector.
Engage the 2 guides and 4 claws to install the No. 2 instrument panel under cover sub-assembly.
| 3. INSTALL INSTRUMENT SIDE PANEL RH |
Engage the 3 guides.
![]() |
Engage the 4 claws to install the instrument side panel RH as shown in the illustration.
| 4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH |
| 5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH |
| 6. INSTALL FRONT DOOR SCUFF PLATE RH |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. PERFORM DIAGNOSTIC SYSTEM CHECK |
| 9. INSPECT SRS WARNING LIGHT |