FRONT PASSENGER AIRBAG ASSEMBLY (for TMMK Made) > INSTALLATION |
| 1. INSTALL NO. 2 INSTRUMENT PANEL WIRE |
![]() |
Connect the 2 airbag connectors of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.
| *1 | Airbag Connector |
| *2 | Airbag Connector Lock |
Push in the 2 locks to install the 2 airbag connectors to the instrument panel passenger airbag assembly.
Engage the clamp.
| 2. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY |
![]() |
Engage the 3 hooks as shown in the illustration.
Push the instrument panel passenger airbag assembly to engage the 3 hooks.
Install the 2 screws to install the instrument panel passenger airbag assembly.
| 3. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY |
Engage the 5 guides and temporarily install the instrument panel safety pad assembly as shown in the illustration.

Install the 2 clips.
Install the 3 bolts <B> and nut <F> or <G>.
Install the 2 passenger airbag bolts <A>.
Engage each clamp.
Connect each connector.
Engage the clamp.
Install the radio tuner mounting bracket with the 2 bolts <B>.
| 4. CONNECT NO. 2 INSTRUMENT PANEL WIRE |
Check that the engine switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Connect the connector.
| 5. INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY |
| 6. PERFORM DIAGNOSTIC SYSTEM CHECK |