Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY (for TMC, TMMR Made)

FRONT PASSENGER AIRBAG ASSEMBLY (for TMC, TMMR Made) > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing (Click here).

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
(Click here)


3. DISCONNECT NO. 2 INSTRUMENT PANEL WIRE
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    B288991E01
  1. Slide the slider to release the lock, and then disconnect the connector.
    Text in Illustration 
    *a
    Slider

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.



4. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY


  1. Disconnect each connector.


    B373547E01


    Text in Illustration 
    *A
    w/ Ion Generator
    -
    -

  1. Disengage each clamp.



    B284917
  1. Disconnect the glove box light as shown in the illustration.



  1. Remove the 2 passenger airbag bolts <A>.


    B281789E01


    Text in Illustration 
    *1
    Passenger Airbag Bolt <A>
    *2
    Bolt <B>
    *3
    Nut <E> or <F>
    *4
    Clip

  1. Remove the 3 bolts <B> and nut <E> or <F>.

  1. Remove the 2 clips.



  1. Disengage the 5 guides and remove the instrument panel safety pad assembly as shown in the illustration.


    B281790

    NOTICE:
    1. Do not damage the instrument panel safety pad assembly.
    2. Do not allow the wire harnesses to interfere with the surrounding parts.



5. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

CAUTION:
When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.



    B286454
  1. Remove the 2 screws.



    B286458
  1. Lean the instrument panel safety pad assembly and disengage the 3 hooks.



    B286459
  1. Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the instrument panel safety pad assembly.



6. REMOVE NO. 2 INSTRUMENT PANEL WIRE


    B286460E01
  1. Disengage the clamp.

  1. Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Airbag Connector
    *3
    Airbag Connector Lock

  1. Disconnect the airbag connector to remove the No. 2 instrument panel wire from the instrument panel passenger airbag assembly.

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.